www.laboshop.com 5 6 1 2 3 4 FINO the fine difference 1 Dr. Hinz BaseModel Unit For the fixation of three-dimensionally orientated models. The uniform height of the models of 60 mm is pre-determined by the base model unit. each 700.406 , 2Dr. Hinz BaseModel Trays For the mounting of upper and lower orthodontic models with flexible plug-in connectors for the fixation of models into the Dr. Hinz base model unit. Technical data: length 85 mm; width upper jaw 65 mm, lower jaw 60 mm; height 20 mm. 100 pairs 1 pack. 700.423 , plug connectors, 200 pcs. 1 pack. 700.411 , 3FINO BaseModel Trays Suitable for the fixation of orthodontic models into the Dr. Hinz base model unit. With flexible plug connectors. Technical data: length 85 mm; width upper jaw 65 mm, lower jaw 60 mm; height 20 mm. Delivery includes: each 100 FINO base model trays for upper and lower jaw; 200 FINO plug connectors. 1 set 700.439 , plug connectors, 200 pcs. 1 pack. 700.443 , 4FINO BaseModel Moulds Stable, to base in orthodontic upper jaw and lower jaw models without using a base model unit. Including plug connectors, 200 pcs., wide. Technical data: small: length 80 mm; width 65 mm; height 20 mm. Large: length 85 mm; width 70 mm; height 20 mm. 100 pcs. 1 pack. 700.376 small , 700.386 large , 5FINOORTHO STONE Orthodontic Hard Plaster Type III. Special plaster ro produce anatomic casts and control models for orthodontic works. The high quality also allows the use in prosthetics, e.g. the production of counter bite and repair models. Advantages: • Smooth model surface; • Optimum hardness for orthodontics; • High degree of whiteness; • High strength; • Low expansion. Physical data: processing time 4-5 min; setting time 8-9 min; setting expansion after 2 h < 0.15 %; compressive strength after 1 h > 39 N/mm², after 24 h 50 N/mm². white each 100.519 bucket, 10 kg , 100.509 cardboard box, 25 kg , Trial pack, 1000 g each 100.50P6 white , 6FINOPLASTER Orthodontic Hard Plaster Type III. To produce anatomic casts and control models for orthodontic works. Also suitable for counter bite, repair and presentation models. Advantages: • Smooth model surface; • High edge stability; • Good flow properties; • Low expansion. Physical data: processing time 5-6 min; setting time 10-12 min; setting expansion after 2 h 0.14 %; compressive strength after 1 h 25 N/mm², after 24 h 60 N/mm². white, 25 kg each 100.326 ,
RkJQdWJsaXNoZXIy MTI3MDM=