www.laboshop.com You will find the Ivoclar Vivadent Programat EP 3010 and EP 5010 pressing and firing furnaces on page 524. Basic kit A-D: 1 IPS e.max ZirPress MO (MOA2) 5 pcs. each; 4 IPS e.max ZirPress LT (LTA1-LTA3, LTB1) 5 pcs. each; 4 IPS e.max ZirPress HT (HTA1-HTA3, HTB1) 5 pcs. each; 1 IPS e.max ZirPress gingiva (G4) 5 pcs. each; 1 IPS mould system 100 g (mould base, mould gauge, silicone ring); 1 IPS mould system 200 g (mould base, mould gauge, silicone ring); 1 IPS sprue guide 100 g; 1 IPS sprue guide 200 g; 2 IPS alox plungers; 1 IPS alox plunger separator 200 mg; 1 IPS e.max Press Invex can; 1 IPS natural die material shade guide. 1 set 033.296 . , IPS e.max ZirPress HT High Translucency blanks for the staining and cut-back technique. For pressing over of ZrO2 crown frames in the anterior and posterior area, multi-unit ZrO2 bridge frames in the anterior and posterior area, ZrO2 inlay bridge frames, implant abutments/suprastructures made from ZrO2 . Also for the pressing of veneers. Blanks Item-no. Shades Quantity 1 pack HT 033.1* HTBL1-HTBL4, HTA1-HTD4 5 pcs. , IPS e.max ZirPress LT Low Translucency blanks for the staining and cut-back technique. For pressing over of ZrO2 crown frames in the anterior and posterior area, multi-unit ZrO2 bridge frames in the anterior and posterior area, implant abutments/suprastructures made from ZrO2 . Also for the pressing of veneers. Blanks Item-no. Shades Quantity 1 pack LT 033.1* LTBL1-LTBL4, LTA1-LTD4 5 pcs. , IPS e.max ZirPress Gingiva Gingiva blanks for pressing on gingiva parts onto ZrO2 frames particularly in case of implant suprastructures. Blanks Item-no. Shades Quantity 1 pack Gingiva 033.1* G3, G4 (GG3, GG4) 5 pcs. , Please order blanks by quoting the desired shade after the item number instead of *. **This item is not available in all countries. Please contact your customer service expert. Ivoclar Vivadent IPS e.max ZirPress Pressed All-Ceramic** Fluor-apatite glass ceramic blanks for pressing over of IPS e.max ZirCAD and other ZrO2 frames in the CTE range from 10.5 to 11.0 x 10-6K-1. The fluor-apatite crystals are present in different sizes. This controls the combination of translucence, opalescence and brightness. Advantages: • Creation of ZrO2 supported restorations with low technical and timely effort; • Accurately fitting and firing-stable ceramic shoulders; • Natural aesthetics. Physical data: CTE 9.8 x 10-6K-1 (100-500 °C); press temperature 900-910 °C; flexural strength (biaxial) 110 N/mm²; Vickers hardness 5400 N/mm²; chemical solubility 30 µm/cm².
RkJQdWJsaXNoZXIy MTI3MDM=