www.laboshop.com 1 2 3 4 5 1 Dentsply Sirona Celtra Press Pressed All-Ceramic Made from ZrO2 reinforced lithiumsilicate ceramic (ZLS) with micro structure. Can be veneered with Celtra Ceram veneering porcelain and characterised with Dentsply Sirona universal stains. Advantages: • Chameleon-effect for an optimum visual matching in vivo; • Perfect balance of translucency and opalescence; • Natural opalescence for less intraoral greying; • High tensile strength of more than 500 N/mm² for reliable results; • Outstanding quality of the margins – more reliability also in complex cases; • Very good flow properties due to smaller ZLS micro crystals, only one press sprue for a three-unit bridge; • Simple and more accurate selection of blanks, few shades cover a huge part of the colour spectrum; • The correct shade already in the blank, hardly any adjustments in hue, colour brightness and saturation required; • Self-adhesive or full-adhesive luting, depending on the indication. Physical data: CTE 9.7 x 10-6K-1 (25-500 °C); press temperature 860-870 °C; softening temperature 820 °C; glass transition temperature 560 °C; flexural strength after PowerFire firing > 500 N/mm²; chemical solubility < 30 µg/cm². Starter kit: 2 packs Celtra Press MT (MT A2, MT A3) 5 x 3 g each; 2 prosthetics die material (F10, F12) 4 g each; 1 Celtra cervical and underlining wax 60 g; 1 Celtra modelling wax 60 g; 1 Celtra Press investment material 100 g; 1 Celtra Press mixing liquid 100 ml; 1 mould former and mould gauge 100 g; 1 rubber sleeve 100 g; 2 press plungers; 2 Celtra Ceram enamel (E2, E3) 15 g each; 1 universal modelling liquid DU 15 ml; 1 universal overglaze (high flu) 5 g; 1 universal stain and glaze liquid 15 ml; 1 set firing pins; 3 pcs. firing fleece. 1 set 028.738 , 2-4Dentsply Sirona Mould System For Celtra Press and pressed all-ceramic blanks with a diameter of 13 mm. 2mould former and mould gauge 1 set 029.548 for mould g , 029.558 for mould 200 g , 3 rubber sleeve each 029.528 for mould g , 029.538 for mould g , 4 press plungers, 25 pcs. 1 pack. 029.568 , 5Dentsply Sirona Celtra Press Investment Material Phosphate-bonded, developped for Celtra Press and lithium disilicate pressed all-ceramics. Speed and conventional heating. Advantages: • Minimum reaction layer, treatment of objects with acid after blasting is not required; • Accurate expansion control for an optimum fit; • Extraordinary flow properties due to the micro-structure; • Dust-reduced as a health precaution; • Universally applicable for all press-ceramics. Physical data: processsing time 4.5-9 min; setting time 5.5-12 min; total expansion linear 0.3-1.2 %; compressive strength 4-15 N/mm²; mixing ratio 100 g : 22 ml. powder 1 pack. 029.498 x g , mixing liquid each 029.508 ml ,
RkJQdWJsaXNoZXIy MTI3MDM=